Upside-down Piranha Plant (npc-51) not aligned properly [Solved]

[Sambo]

The upside-down Piranha Plant has no offset on the grid, so it isn't lined up properly when placing. I checked the config file, and "grid-offset-x" for that NPC is set to 16, but it doesn't seem to have any effect.

[Wohlstand]

The upside-down Piranha Plant has no offset on the grid, so it isn't lined up properly when placing. I checked the config file, and "grid-offset-x" for that NPC is set to 16, but it doesn't seem to have any effect.

grid-offset values should be less than 1/2 of grid value to have effect.

[Sambo]

The grid offset is half of the grid size. The plant isn't lined up correctly, though, and I didn't change anything in the config file. (on that NPC)

[Wohlstand]

The grid offset is half of the grid size. The plant isn't lined up correctly, though, and I didn't change anything in the config file. (on that NPC)

Oh, may by you have old configs? I just remember, was a discussion about them where we fix them.

http://www.supermariobrosx.org/forums/viewtopic.php?p=76634#p76634

So this means, I need to use the "grid-attachement-style=1", to align the piranha plant into the center then? Because it would need 16 pixels to get aligned right, but you say I cannot use more than half of the "grid=32"-value, which would be a "grid-offset-x=16". Am I right, or do I still misunderstand that?

I think, I will make easer:
I will set grid size 16x16 AND to upside piranha, and to Piranhacus Giganticus.

Before fix:


After config update to grid=16, grid offset x=8 for Piranhacus Giganticus (upside piranga I was leave with current)

Note: All offsets and positions I was researched directly from SMBX, and when you will try same in the SMBX, you will see same bug, but in PGE you always can edit grid size and offset for each item.

[Sambo]

I just set the grid size to 16x16 to fix the issue.